In meinem Haus gibt es mehrere Steckdosen wie diese. Wenn man ein Kabel herauszieht, wird die gesamte Steckdose aus der Wand gezogen. Dem Handwerker meines Vermieters ist das egal und er hat uns einfach eine Möglichkeit gegeben, es selbst zu machen, als ich es ihm gezeigt habe. Ich bin mir nicht sicher, wie die Zinken an der Seite wieder in das Rohr in der Wand passen sollen. Helfen!
https://i.redd.it/5yxouxsrpaeg1.jpeg
Von SpiciestSpecialist
10 Kommentare
Toddler got the doomfist
Remove the front cover by unscrewing the screw in the middle. There should be screws to ‚relax‘ those prongs.
Put the socket back in and tighten the screws that spread the prongs outward. For safety turn off electricity at the box first
I renovated a old German home and did this along with my electrician fam member. First order of business is to turn off the circuit breaker to that room before touching it. The one you are showing there appears to be the ones with two prongs that when you screw the face place on, it pushes the prongs outward to grip into the inside of outlet mounted hole. Honestly, have somebody who is trained/safe with electricity to do it for you. Not worth getting hurt. Your landlord should be the one responsible for this, not you, especially with a kid in the house.
Turn off the breaker to make sure you get no shock while doing the below:
There is a screw in the center of the outlet. Remove that one, then you can remove the frame and the cover.
Push the socket back into the hole. On the left and on the right there is a clamp which is supposed to hold the socket inside. Make sure there is no cable in between the clamp and the wall.
You will see one screw on each side on the left and the right of the socket, these are used to tighten the clamps. Fix the screws until the plug sits tight.
Install the cover and the frame again and turn in the breaker.
Turn off the power at the fuse box, unplug the device and then unscrew the littke screw in the middle of the socket and and you can remove the plastic cover, then there are two screws either side of the metal mounting plste that push out little arms from to hold the socket in the wall, so back thrm off a littke so you can get it back I to the wall, then screw them back in and they will press out into the hole and hold the socket in. Then put the plastic cover back on, and put the screw back on the middle.
Not you can put the power back on at the fuse box, and should be good to go.
Obviously if you rent you should really get your land lord to fix it or get an eke yricisn to do it.
Never work on live circuits.
You can check it’s off by plugging a lamp into it and turn it on, then be sure it goes off with the main fuse box.
I would insist to get it fixed to be safe.
But here is how it’s done in theory:
1. Pull the breaker off for this circuit
2. Check if it’s shut off with a two-contact voltage tester.
3. Remove the plastic cap which is held by a screw.
4. The socket has 2 screws on the side to push the prongs out. Unscrew them so you can push the prongs back in.
5. Push the socket in the wall. Make sure that no cable gets trapped on the side which might be damaged by the prongs!
6. Screw the prongs in to tighten the socket again.
7. Mount the plastic cover.
Can you give the toddler back?
Whatever you do, turn off power first and make sure it is off!
That toddler is the next mike tyson fs
Is the Todler related to Brock Lesnar 🤣